丽江高美古台址和2m级望远镜项目(英文)     

陈东  王建成  许骏  罗国权  谭徽松  刘忠  张柏荣 《天文研究与技术》2003,(Z1)

自 1992年起云南天文台开始了在云南省西北部的天文选址。丽江高美古最终被选择作为未来中国地基天文光学观测的新址点。并且 ,在国家科技部 ,云南省政府 ,以及中科院的支持下 ,2m级天文望远镜项目在 2 0 0 0年 12月获得立项。在文中 ,我们简要的介绍了高美古台址的情况 ,并给出了 2 .4m望远镜的详细情况 ,以及其他相关情况。  相似文献   

Gamma-rays and cosmic rays from a pulsar in Cygnus OB2     

W. Bednarek 《Monthly notices of the Royal Astronomical Society》2003,345(3):847-853

We argue that γ-ray sources observed in the direction of the Cygnus OB2 association in the GeV and TeV energy range are due to a pulsar that was created by a supernova a few tens of thousands of years ago. The GeV emission is produced by a middle-aged pulsar, a factor of 2 older than the Vela pulsar. The TeV emission is produced by high-energy hadrons and/or leptons accelerated in pulsar wind nebulae. We suggest, moreover, that the excess of cosmic rays at ∼10¹⁸ eV observed from the direction of the Cygnus region can also be related to the appearance of this very energetic pulsar in the Cyg OB2 association. Some of the relativistic hadrons, captured in strong magnetic fields of a high-density region of Cyg OB2, produce neutrons and γ-rays in collisions with matter. These neutrons can arrive from Cyg OB2, creating an excess of cosmic rays.  相似文献   

Supercritical gas sorption on moist coals   总被引：2，自引：1，他引：1  

Stuart Day  Richard Sakurovs  Steve Weir 《International Journal of Coal Geology》2008,74(3-4):203-214

The effect of moisture on the CO₂ and CH₄ sorption capacity of three bituminous coals from Australia and China was investigated at 55 °C and at pressures up to 20 MPa. A gravimetric apparatus was used to measure the gas adsorption isotherms of coal with moisture contents ranging from 0 to about 8%. A modified Dubinin–Radushkevich (DR) adsorption model was found to fit the experimental data under all conditions. Moisture adsorption isotherms of these coals were measured at 21 °C. The Guggenheim–Anderson–de Boer (GAB) model was capable of accurately representing the moisture isotherms over the full range of relative pressures.Moist coal had a significantly lower maximum sorption capacity for both CO₂ and CH₄ than dry coal. However, the extent to which the capacity was reduced was dependent upon the rank of the coal. Higher rank coals were less affected by the presence of moisture than low rank coals. All coals exhibited a certain moisture content beyond which further moisture did not affect the sorption capacity. This limiting moisture content was dependent on the rank of the coal and the sorbate gas and, for these coals, corresponded approximately to the equilibrium moisture content that would be attained by exposing the coal to about 40–80% relative humidity. The experimental results indicate that the loss of sorption capacity by the coal in the presence of water can be simply explained by volumetric displacement of the CO₂ and CH₄ by the water. Below the limiting moisture content, the CO₂ sorption capacity reduced by about 7.3 kg t^− 1 for each 1% increase in moisture. For CH₄, sorption capacity was reduced by about 1.8 kg t^− 1 for each 1% increase in moisture.The heat of sorption calculated from the DR model decreased slightly on addition of moisture. One explanation is that water is preferentially attracted to high energy adsorption sites (that have high energy by virtue of their electrostatic nature), expelling CO₂ and CH₄ molecules.  相似文献   

Magnetotelluric investigations for imaging electrical structure of Garhwal Himalayan corridor,Uttarakhand, India     

M. Israil  D. K. Tyagi  P. K. Gupta  Sri Niwas 《Journal of Earth System Science》2008,117(3):189-200

Magnetotelluric investigations have been carried out in the Garhwal Himalayan corridor to delineate the electrical structure of the crust along a profile extending from Indo-Gangetic Plain to Higher Himalayan region in Uttarakhand, India. The profile passing through major Himalayan thrusts: Himalayan Frontal Thrust (HFF), Main Boundary Thrust (MBT) and Main Central Thrust (MCT), is nearly perpendicular to the regional geological strike. Data processing and impedance analysis indicate that out of 44 stations MT data recorded, only 27 stations data show in general, the validity of 2D assumption. The average geoelectric strike, N70°W, was estimated for the profile using tensor decomposition. 2D smooth geoelectrical model has been presented, which provides the electrical image of the shallow and deeper crustal structure. The major features of the model are (i) a low resistivity (<50Ωm), shallow feature interpreted as sediments of Siwalik and Indo-Gangetic Plain, (ii) highly resistive (> 1000Ωm) zone below the sediments at a depth of 6 km, interpreted as the top surface of the Indian plate, (iii) a low resistivity (< 10Ωm) below the depth of 6 km near MCT zone coincides with the intense micro-seismic activity in the region. The zone is interpreted as the partial melting or fluid phase at mid crustal depth. Sensitivity test indicates that the major features of the geoelectrical model are relevant and desired by the MT data.  相似文献   

Quick-look assessments to identify optimal CO2 EOR storage sites   总被引：1，自引：0，他引：1  

Vanessa Núñez-López  Mark H. Holtz  Derek J. Wood  William A. Ambrose  Susan D. Hovorka 《Environmental Geology》2008,54(8):1695-1706

A newly developed, multistage quick-look methodology allows for the efficient screening of an unmanageably large number of reservoirs to generate a workable set of sites that closely match the requirements for optimal CO₂ enhanced oil recovery (EOR) storage. The objective of the study is to quickly identify miscible CO₂ EOR candidates in areas that contain thousands of reservoirs and to estimate additional oil recovery and sequestration capacities of selected top options through dimensionless modeling and reservoir characterization. Quick-look assessments indicate that the CO₂ EOR resource potential along the US Gulf Coast is 4.7 billion barrels, and CO₂ sequestration capacity is 2.6 billion metric tons. In the first stage, oil reservoirs are screened and ranked in terms of technical and practical feasibility for miscible CO₂ EOR. The second stage provides quick estimates of CO₂ EOR potential and sequestration capacities. In the third stage, a dimensionless group model is applied to a selected set of sites to improve the estimates of oil recovery and storage potential using appropriate inputs for rock and fluid properties, disregarding reservoir architecture and sweep design. The fourth stage validates and refines the results by simulating flow in a model that describes the internal architecture and fluid distribution in the reservoir. The stated approach both saves time and allows more resources to be applied to the best candidate sites.  相似文献   

On CO<Subscript>2</Subscript> fluid flow and heat transfer behavior in the subsurface,following leakage from a geologic storage reservoir   总被引：1，自引：0，他引：1  

Karsten Pruess 《Environmental Geology》2008,54(8):1677-1686

Geologic storage of CO₂ is expected to produce plumes of large areal extent, and some leakage may occur along fractures, fault zones, or improperly plugged pre-existing wellbores. A review of physical and chemical processes accompanying leakage suggests a potential for self-enhancement. The numerical simulations presented here confirm this expectation, but reveal self-limiting features as well. It seems unlikely that CO₂ leakage could trigger a high-energy run-away discharge, a so-called “pneumatic eruption,” but present understanding is insufficient to rule out this possibility. The most promising avenue for increasing understanding of CO₂ leakage behavior is the study of natural analogues.  相似文献   

Screening and ranking framework for geologic CO<Subscript>2</Subscript> storage site selection on the basis of health,safety, and environmental risk   总被引：2，自引：0，他引：2  

Curtis M. Oldenburg 《Environmental Geology》2008,54(8):1687-1694

A screening and ranking framework (SRF) has been developed to evaluate potential geologic carbon dioxide (CO₂) storage sites on the basis of health, safety, and environmental (HSE) risk arising from CO₂ leakage. The approach is based on the assumption that CO₂ leakage risk is dependent on three basic characteristics of a geologic CO₂ storage site: (1) the potential for primary containment by the target formation; (2) the potential for secondary containment if the primary formation leaks; and (3) the potential for attenuation and dispersion of leaking CO₂ if the primary formation leaks and secondary containment fails. The framework is implemented in a spreadsheet in which users enter numerical scores representing expert opinions or published information along with estimates of uncertainty. Applications to three sites in California demonstrate the approach. Refinements and extensions are possible through the use of more detailed data or model results in place of property proxies.  相似文献   

Seal integrity and feasibility of CO<Subscript>2</Subscript> sequestration in the Teapot Dome EOR pilot: geomechanical site characterization     

Laura Chiaramonte  Mark D. Zoback  Julio Friedmann  Vicki Stamp 《Environmental Geology》2008,54(8):1667-1675

This paper reports a preliminary investigation of CO₂ sequestration and seal integrity at Teapot Dome oil field, Wyoming, USA, with the objective of predicting the potential risk of CO₂ leakage along reservoir-bounding faults. CO₂ injection into reservoirs creates anomalously high pore pressure at the top of the reservoir that could potentially hydraulically fracture the caprock or trigger slip on reservoir-bounding faults. The Tensleep Formation, a Pennsylvanian age eolian sandstone is evaluated as the target horizon for a pilot CO₂ EOR-carbon storage experiment, in a three-way closure trap against a bounding fault, termed the S1 fault. A preliminary geomechanical model of the Tensleep Formation has been developed to evaluate the potential for CO₂ injection inducing slip on the S1 fault and thus threatening seal integrity. Uncertainties in the stress tensor and fault geometry have been incorporated into the analysis using Monte Carlo simulation. The authors find that even the most pessimistic risk scenario would require ∼10 MPa of excess pressure to cause the S1 fault to reactivate and provide a potential leakage pathway. This would correspond to a CO₂ column height of ∼1,500 m, whereas the structural closure of the Tensleep Formation in the pilot injection area does not exceed 100 m. It is therefore apparent that CO₂ injection is not likely to compromise the S1 fault stability. Better constraint of the least principal stress is needed to establish a more reliable estimate of the maximum reservoir pressure required to hydrofracture the caprock.  相似文献   

Heat capacity and phase equilibria of wadeite-type K2Si4O9     

Wenjun Yong  E. Dachs  A. C. Withers  E. J. Essene 《Contributions to Mineralogy and Petrology》2008,155(2):137-146

The low-temperature heat capacity (C _p) of Si-wadeite (K₂Si₄O₉) synthesized with a piston cylinder device was measured over the range of 5–303 K using the heat capacity option of a physical properties measurement system. The entropy of Si-wadeite at standard temperature and pressure calculated from the measured heat capacity data is 253.8 ± 0.6 J mol⁻¹ K⁻¹, which is considerably larger than some of the previous estimated values. The calculated phase transition boundaries in the system K₂O–Al₂O₃–SiO₂ are generally consistent with previous experimental results. Together with our calculated phase boundaries, seven multi-anvil experiments at 1,400 K and 6.0–7.7 GPa suggest that no equilibrium stability field of kalsilite + coesite intervenes between the stability field of sanidine and that of coesite + kyanite + Si-wadeite, in contrast to previous predictions. First-order approximations were undertaken to calculate the phase diagram in the system K₂Si₄O₉ at lower pressure and temperature. Large discrepancies were shown between the calculated diagram compared with previously published versions, suggesting that further experimental or/and calorimetric work is needed to better constrain the low-pressure phase relations of the K₂Si₄O₉ polymorphs. Electronic supplementary material The online version of this article (doi:) contains supplementary material, which is available to authorized users.  相似文献   

Experimental constraints on the effects of pressure and H2O on the fractional crystallization of high-Mg island arc basalt     

Morihisa Hamada  Toshitsugu Fujii 《Contributions to Mineralogy and Petrology》2008,155(6):767-790

H₂O-undersaturated melting experiments of synthesized basalt (SiO₂ = 50.7 wt.%, MgO = 8.3 wt.%, Mg# = 60) were conducted at fO₂ corresponding to NNO+1 and NNO−1 to clarify the effects of pressure (2–7 kbar) and H₂O on fractional crystallization in island arcs. H₂O content was ranged from nominally anhydrous to 4.4 wt.%. Differentiation trends, namely the liquid lines of descent, change sensitively according to pressure-H₂O relations. Tholeiitic differentiation trends are reproduced with H₂O ≤ ∼2 wt.% in primary magma. With such quantities of H₂O, fractional crystallization is controlled by olivine + plagioclase at 2 kbar. Increasing the pressure from 2 to ≥4 kbar induces early crystallization of orthopyroxene instead of olivine and therefore SiO₂ enrichment in the residual melts is suppressed. Increasing H₂O (≥ ∼2 wt.% in primary magma) stabilizes clinopyroxene relative to orthopyroxene and/or magnetite. Although the phase relations and proportions strongly depend on fO₂ and H₂O content, differentiation trends are always calc-alkaline.  相似文献